Instruction manual

REMOTE CONTROL

Before making any connections to the switcher, observe the following:

• Ensure the mains voltage supply matches the label on the supplied plug- Pack (+/- 10%).

• Ensure that the power switch is OFF.

• Ensure that all system grounds (earth) are connected to a common point.

• Avoid powering equipment within a system from multiple power sources that may be separated by large distances.

• Connect all audio video sources and destination equipment.

• Power up all source and destination audio-visual sources.

• For each destination output, select the appropriate input source by using the front panel input 1~16 buttons, the supplied IR remote control,

or through the RS-232 serial communication port.

• Upon power up the switcher will return to its last used setting before Powered down.

REMOTE CONTROL

IR REMOTE CONTROL KEY :

IR REMOTE : SW-5669

1. & 2. SWITCH POWER ON or OFF:

Controller with a power ON and OFF

3. DESTINATION : 1 thru 16 OUTPUT SELECTION:

Press the destination button to select the output display channel.

4. SOURCE : 1 thru 16 INPUT SOURCE SELECTION:

Press input 1~16 sources with selection button

5. FUNCTION KEY:

ALL - function selection button

OFF - function selection button

EDID - function selection button

RECALL - function selection button

ENTER - function selection button

MEMORY - function selection button

LOCK - function selection button