Instruction manual

EDID FUNCTION
EDID FUNCTION SETUP
EDID Setup To Change the EDID Setup
Step 1. Press the EDID button The display will show the currently selected EDID mode
Step 2. Press SOURCE #1 or #2 button row The button will fl ash blue and the display will show the current Embedded EDID Status.
Step 3. Press the ENTER button To set EDID mode. The switcher will return to operation mode.
Operation will abort if no keys are pressed within 5 seconds.
Embedded EDID Modes Total 8 EDID Modes
Embedded EDID setup
Press EDID > SOURCE > ENTER
SOURCE #1
or
SOURCE #2
To select Embedded EDID mode or LEARNING mode.
Press EDID button: The LCM will show the current EDID status.
Repeatedly depressing the Source 1 button will cycle up thru the options.
Repeatedly depressing the Source 2 button will cycle down thru the options.
Select Embedded EDID :Mode 1 : FSS
Mode 2 : H24-3D
Mode 3 : H24-3D-M
Mode 4 : H36-3D
RESET EDID Return To Factory default
How to RESET EDID mode
Press EDID > SOURCE > ENTER
To RESET the FACTORY DEFAULT (1080p-2CH).
Press EDID button : The LCM will show the current EDID status.
Press RECALL button : The LCM will show the RESET EDID.
Press ENTER to confi rm entries.
The EDID will return to FSS mode and resolution 1080p-2CH.
EDID FUNCTION FOR HDMI MATRIX SWITCHER
LEARNING EDID Learning EDID from Destination to Source
Learning EDID Setup
Press EDID > DESTINATION >
SOURCE > ENTER
Press EDID > DESTINATION Button:
The LCM will be show LEARNING.
Switcher will LEARN destination EDID and pass the selected source.
NOTE : The already learned EDID cannot be modifi ed. You can only rebuild a new Learning EDID.
For example:
When the Source has “Learned” the EDID data from a destination, It will save that EDID information into EPROM and the EDID
data cannot change.
Please select new learning destination to sources or change to one of the embedded EDID modes when you want to remove
the learning EDID memory from EPRPM.
9
Mode 5 : H36-3D-M
Mode 6 : 1280x1024-60Hz
Mode 7 : 1920x1200-60Hz
Mode 8 : AUTO