Instruction manual

REMOTE CONTROL

Before making any connections to the SB-8188CT. Observe the following:

• Ensure the mains voltage supply matches the label on the supplied plug- Pack (+/- 10%).

• Ensure that the power switch is OFF.

• Ensure that all system grounds (earth) are connected to a common point.

• Avoid powering equipment within a system from multiple power sources that may be separated by large distances.

• Connect all audio video sources and destination equipment.

• Power up all source and destination audio-visual sources.

• For each destination output select the appropriate input source by using The front panel input 1-8 select buttons. The supplied IR remote

control. Or through the RS-232 serial communications port.

• Upon power up the switcher will return to its last used setting before Powered down.

REMOTE CONTROL

IR REMOTE CONTROL KEY :

1. & 2. SWITCH POWER ON or OFF:

Controller with a power ON and OFF

3. INPUT 1~8 VGA MONITOR INPUTS SELECTION:

Input - 1 : CAT5 connect to VGA+Audio Display / Monitor

Input - 2 : CAT5 connect to VGA+Audio Display / Monitor

Input - 3 : CAT5 connect to VGA+Audio Display / Monitor

Input - 4 : CAT5 connect to VGA+Audio Display / Monitor

Input - 5 : CAT5 connect to VGA+Audio Display / Monitor

Input - 6 : CAT5 connect to VGA+Audio Display / Monitor

Input - 7 : CAT5 connect to VGA+Audio Display / Monitor

Input - 8 : CAT5 connect to VGA+Audio Display / Monitor

4. OUTPUT 1~8 VGA SOURCES OUTPUT SETUP:

Output -1 : VGA-1 VGA+Audio Signal from source device

Output -2 : VGA-2 VGA+Audio Signal from source device

Output -3 : VGA-3 VGA+Audio Signal from source device

Output -4 : VGA-4 VGA+Audio Signal from source device

Output -5 : VGA-5 VGA+Audio Signal from source device

Output -6 : VGA-6 VGA+Audio Signal from source device

Output -7 : VGA-7 VGA+Audio Signal from source device

Output -8 : VGA-8 VGA+Audio Signal from source device

CONNECTING THE HARDWARE

Please study the panel drawings below and become familiar with the signal input-output, Power requirements plus any controls present.

Before using the switcher, please take the time to make certain that the device you wish to connect to its inputs is functioning properly in

all respects. Verify that the video and audio signals are present and are being displayed properly on a suitable device.

If all is well connect the appropriate cables between the output of the device you wish to distribute to output(s) of the switcher to the

carious devices you wish to feed a signal to. Lastly, connect the AC to DC adaptor, connect the DC connector to the switcher ﬁ rst and then

plug the adaptor into a functional AC outlet.