Instruction manual

BACK PANEL
BACK PANEL
4
1. DC POWER INLET:
The switcher is fi tted with a DC power plug input connector.
Please ensure that the plug used is of an approved type and is
of suffi cient current carrying capacity with the correct voltage and
connector polarity. 12Volt DC power supply 3A Max.
2. OUTPUT - 1 PREVIEW:
Support Preview Output VGA / Audio sources as same signals
as the output-1.
3. RS-232 CONNECTION:
RS-232 control port to allow for interfacing to a PC, such as a
computer or touch panel control, to the switcher via this DB-9pin
Female connector for serial RS-232 control.
4. INPUT - 1~8 VGA-RGBHV-AUDIO PORTS:
Connect a signal 8x sources of VGA (RGBHV) / Stereo Audio
device to 8x CAT5 outputs matrix switcher.
Input 1~8 port source signals :
- VGA (RGBHV), 1x HD-15p Connectors
- Stereo Audio(AR/AL), 1x O3.5mm ear phone jack.
5. OUTPUTS - 1~8 CAT5 (VGA+AUDIO) PORTS:
Connect a signal 8x sources of VGA (RGBHV) / Stereo Audio
device to 8x CAT5 outputs matrix switcher.
For use with any combination of ShinybowUSA receivers SB-
6110R, SB-6210R, SB-6310R.
Power Jack:
DC Jack - Inner OD Ø 2.1 mm (+)
Outside OD Ø 5.5mm (GND)
Power input -12VDC, 3A
Switcher power supply use universal part number TA 007
VGA (RGBHV) Via 1x HD-15p connector
Stereo Audio(AR/AL) Via 1x O3.5mm ear phone jack
connector.
Note: With 2x female connectors
Remote port : DB-9pin Female connector
VGA (RGBHV) Via 1x HD-15p connector
Stereo Audio(AR/AL) Via 1x O3.5mm ear phone jack
connector.
Note: With 2x female connectors
Output 1~8 CAT5 port signals :
- CAT5 VGA (RGBHV) + Audio
Note: With 1x CAT5 RJ45 connector.