Instruction manual

39
The following shows the indication during Run output.
PTN display : Selected program pattern number
PV display : Current actual temperature
STEP display : Step number of the program
control which is running
SV display : Current step SV
RUN indicator : Lit
EVT indicator : Lit while Run output is ON
Other indicators: Lit or unlit according to the
controller status
7.3 Stopping program control
Pressing the Key for 1 second or longer stops the program control.
The program control also stops by disconnecting (Contact from Closed to Open) external
operation input terminals 14 and 17.
[Indication after program control stops]
PTN display : Selected program pattern number
PV display : Current actual temperature
STEP display : Unlit
SV display : Unlit
All indicators : Unlit
7.4 Advance function (Advances to the next step during program control run)
To cancel the current step and advance to the next step during the program control,
press the Key for 1 second or longer.
This function is also usable during Wait action or during Fixed value control action.
[Indication when Advance function is used at Step 1]
PTN display : Selected program pattern number
PV display : Current actual temperature
STEP display : Step 2 after the Advance
function is used.
SV display : Current step SV
RUN indicator : Lit during program control run
Other indicators: Lit or unlit according to the
controller status
[Time signal action after Advance function is used]
If Advance function is used, only the step time advances. Time signal output timing
does not change.
The following example shows that when Advance function is used during Step 1,
time signal output is turned on 20 minutes after Step 1 is advanced to Step 2.
PTN PV
Actual temp.
STEP SV
Step SV
PTN PV
Actual temp.
STEP SV
PTN PV
Actual temp.
STEP SV
Step SV