Instruction manual

33
[Program standby mode or Program control run mode]
(9) Auxiliary function setting mode 2
The settings in Auxiliary function setting mode 2 have already been completed
in Section “5. Setup” (p.14).
(10) Data clearing function
This function returns all set values to the default values (See pages 58, 59).
This function can only be used during Program standby mode.
This function can not be used during Program control run mode.
Caution
Be sure to write down all set values for all patterns before clearing data, using
the photocopiable pages at the end of this manual.
Once data has been cleared, the set values have to be inputted again since the
lost data can not be restored.
[Program standby mode]
Press the Key for 3 seconds while
holding down the and keys.
+ + (3 sec)
[Data clearing]
All set values are cleared and they return
to their default values.
During data clearing, the PV display indicates
, and other displays are turned off.
[Program standby mode]
After data is cleared, the controller automatically
reverts to the Program standby mode.
PTN PV
Actual temp.
STEP SV
PTN PV
Actual temp.
STEP SV
PTN PV
STEP SV
PTN PV
Actual temp.
STEP SV