Instruction manual

21
6. Operation
Key operation for setup
Key : Selects a program pattern number.
, key : Increases or decreases the numeric value or switches the selecting item.
, Key : Registers the set value (numeric value) or selected item.
By pressing the Key, the controller reverts to the Program standby
mode or Program control run mode. This key is very convenient as the
user can revert to the Program standby mode or Program control run
mode from any setting mode.
Key operation on the Operation flowchart
: Press the Key.
(3 sec) : Press the Key for 3 seconds.
+ : Press the Key while holding down the key.
+ (3 sec) : Press the and keys for 3 seconds.
+ (3 sec) : Press the Key for 3 seconds while holding down the key.
+ + (3 sec) : Press the Key for 3 seconds while holding down the
and keys.
Explanation of Operation flowchart
Step 1 SV
PTN PV
STEP SV
Step SV
A space on the display means nothing is indicated.
Step 1 time
PTN PV
STEP SV
Set value
Explanation of Operation
For the explanation of each setting item (pages 24 to 33), current status of each display
is indicated with diagrams on the left side, and its item name and operation method are
described on the right side.
By pressing the Key, the set value is saved, and the setting item proceeds to the
next one.
PTN PV
STEP SV
PTN PV
STEP SV
(e.g. Pattern 1 is set here.)
If the Key is pressed at Step 1 SV setting, the set
value is saved, and the setting item proceeds to the
[Step 1 time setting].
Setting item
PTN and PV display
STEP and SV display
Step 1 SV setting
Step 1 time setting