Instruction manual

15
(19) Alarm 2 (A2) action delay timer
Sets Alarm 2 (A2) action delay timer.
0 seconds
(20) Event output function
Selects an Event output type.
Time signal
output
(21) Pattern end output time
Sets pattern end output time.
0sec(Continuous
output)
(22) Direct/Reverse control action
Selects Direct(Cooling) or Reverse(Heating) control action.
Reverse
(Heating) control
5.2 Basic operation for setup
The following shows how to enter and set Auxiliary function setting mode 2.
To enter Auxiliary function setting mode 2, press the Key for 3 seconds while
holding down the and keys in the Program standby mode or in the Program
control run mode.
Set or select values with the or key.
To register the values, use the or Key.
Program standby mode or Program control run mode
PTN
[ ]
PV
Actual temp.
STEP
[ ]
SV
[ ]
+ +
(for 3 sec)
Press the Key for 3 seconds while holding down
the and keys.
The unit enters Auxiliary function setting mode 2, and
Input type selection mode appears.
Auxiliary function setting mode 2
PTN
[ ]
PV
[ ]
STEP
[ ]
SV
[ ]
,
Input type
Select a sensor type that matches the users’ with the
or key.
• Default: (K, -200 to 1370 )
PTN
[ ]
PV
[ ]
STEP
[ ]
SV
[ ]
DC voltage input (0 to 1V DC) has been
selected in this example.
Press the Key. The input type will be registered,
and the Scaling high limit setting item will appear.
If any other input type except DC input is selected,
the PV filter time constant setting item will appear.
PTN
[ ]
PV
[ ]
STEP
[ ]
SV
[ ]
PTN
[ ]
PV
[ ]
STEP
[ ]
SV
[ ]
Scaling high limit
Set a value with the or key, and register it with the
Key.
Set other items in the same way according to the users’
conditions.
If the Key is pressed several times or if the
Key is pressed, the controller reverts to the Program
standby mode.
If the Key is pressed, the controller reverts to
the Program standby mode from any mode.
,