Specifications

4. BEEP SIGNALS AND CONDITION SYMBOLS

ＣＵＸＩＩ signals you various messages by four different beep signals and four

symbolic letter as shown as under. These signals and symbol tell you;

(a) instruction to the next operation, (b) warning for faulty operation,

condition.

4-1 Messages by beep

Beep Signal Conditions

Short beep (one time) : Confirmation for pressing the key.

Long beep (one time) : Completion for set data storing.

Short beep (two times)

: Warning for faulty key operation. (Try to re-input)

Short beep (three times)

: Warning for miss key operation. (Stop the

operation)

4-2 Messages by symbolic letters

Symbol Conditions

LIGHT

The UNIT W. is too light for the balance resolution. Impossible to

count, use a balance of smaller capacity.

While flickering, it is possible to count, but a counting error may be

produced due to the rough uniformity of the samples or depending

on the accuracy of the balance.

ADD Please add samples. -- while SCS operation --

NON UNI

The samples are not uniformed or contain some irregular material.

Unload samples until the symbol goes off or pick the irregular

material off from sampling material.

-- while SCS operation --

EXCESS

Too many samples have been added. -- in SCS operation –

Unload samples until the symbol goes off.