Specifications

3. OPERATION KEY FUNCTIONS
ON/OFF : ON/OFF key for the balance.
RE : Improving unit weight by increasing samples.
SCS : Used to command automatic calculation and storage of
average unit weight of sample materials in the unit.
Ｔ : Tare and parameter change
R.M. : Used to recall memorized Unit weight (and Tare) from memory-bank,
inputting code number by the ten-key.
No. : Used to set code numbers for various Unit weight (and Tare)
banking, and memory look up for Unit weight (and Tare).
TARE PRESET : Taring a known tare weight inputting by the ten-keys.
When needing to confirm tare weight, look up current tare value shown
on display for about 2 seconds after press TARE PRESET.
UNT.W. SET : Used to unit weight setting.
Storing of a known unit weight inputting by the ten-keys.
LMT : Used to limit function( comparator ) setting.
Storing of limit value for setting points.
MODE : Function/mode change. Function modes such as bar graph indication,
Auto-Zero, Auto-Power off, stable judgment, resolution select,
Interface, unit selection and the calibration mode could be called by
Pressing the MODE key.
ADD : A key performs like an adding key of a calculating function, adds a
counted result to the total.
SMPL SET : Used to sample quantity setting.
Sampling by inputting known sample quantity from the ten-key.
0 to 9 key : Ten numeric keys, called commonly as ten-keys.
. key : Decimal point key, effective only in the setting of the unit weight and
the tare preset.
C/AC : Used to clear the numbers inputted by the ten-key, unit weight data
and tare preset data clear.
4