Specifications

5-3. Re-Sampling
1. After unit weight is set, load or add (other) samples.*
*too many sampling will cause sampling error.
To avoid an error, bar graph is very useful.
2. Press RE key.
5-4. Counting
1.) Normal counting
Load all the ( remaining ) samples by degrees seeing bar graph.
*if the bar graph goes beyond max/min limits, Re-Sampling should be made
again.
2.) Accumulate counting
1. Unit weight has been set.
2. Load partial samples.
3. Press ADD key.
4. Remove samples.
5. Load other samples in the same way.
6. Press ADD key.
7. Remove samples.
8. If you press MODE key, quantity on the display changes from quantity
for the loaded samples to the accumulated quantity and vice verse.
11