User Manual

37
6. Initial Setting
Setup (setting the Input type, Event output allocation, SV, etc.) should be done before using this
controller, according to the user’s conditions.
Perform setup in Initial setting mode.
Setting items in Initial setting mode are shown in (Table 6.1).
If the user’s specification is the same as the factory default value of this instrument, or if user’s
instrument has already been installed in a system, initial settings are not necessary.
Proceed to Section ‘7. Settings’ (p.53).
(Table 6.1)
Setting Items in Initial Setting Mode
Factory Default
Input type
K -200 to 1370
Scaling high limit
1370
Scaling low limit
-200
Decimal point place
No decimal point
Event output EV1 allocation
No event
EV1 alarm value 0 Enabled/Disabled
Disabled
EV1 alarm value
0
EV1 high limit alarm value
0
EV1 alarm hysteresis
1.0
EV1 alarm delay time
0 sec
EV1 alarm Energized/De-energized
Energized
Event output EV2 allocation (EV2 option)
No event
EV2 alarm value 0 Enabled/Disabled (EV2 option)
Disabled
EV2 alarm value (EV2 option)
0
EV2 high limit alarm value (EV2 option)
0
EV2 alarm hysteresis (EV2 option)
1.0
EV2 alarm delay time (EV2 option)
0 sec
EV2 alarm Energized/De-energized (EV2 option)
Energized
Heater burnout alarm 1 value (C5W, EIW, W options)
0.0 A
Heater burnout alarm 2 value (C5W, EIW, W options)
0.0 A
Loop break alarm time
0 minutes
Loop break alarm span
0
Event input DI1 allocation
(BCS2: EIW, EIT, EI options, BCR2/BCD2: C5W, EIW, EIT, EI options)
No event
Event input DI2 allocation
(BCS2: EIW, EI options, BCR2/BCD2: C5W, EIW, EIT, EI options)
No event
External setting input high limit (EIT option)
1370
External setting input low limit (EIT option)
-200
Transmission output type (EIT option)
PV transmission
Transmission output high limit (EIT option)
1370
Transmission output low limit (EIT option)
-200
SV1
0
SV2 (BCS2: EIW, EIT, EI options, BCR2/BCD2: C5W, EIW, EIT, EI options)
0
SV3 (BCS2: EIW, EI option, BCR2/BCD2: C5W, EIW, EIT, EI options)
0
SV4 (BCS2: EIW, EI option, BCR2/BCD2: C5W, EIW, EIT, EI options)
0