Specifications

YQE8-J0092E17
3.3
Print Density Adjustment
Print density setting is done for every Thermal Head. Therefore after replacing the thermal head, set the print
density by the following procedures.
Turn the Power On by pressing “PAPER SET” and “CLEAR/PAPER REWIND” keys at the same time.
LCD displays “Density Setup Mode” afterwards.
Press “MENU” key.
Press “ENTER” key.
Press “ENTER” key.
This shows the current setting.
By pressing “+” or “-“ keys, change this value to the density that is stated in Thermal Head (Spare
Parts). Press “CLEAR” key until “Ready” appears on LCD.
Confirm the setting value by pressing the "ENTER" key, then press the "CLEAR" key until "Ready"
appears on LCD.
Remarks：Do not change the setting other procedures than explained above. If you have entered to
other setting mode, press “CLEAR” key or turn off the power.
Initializing
DensitySetUpMode
READY：8×10
Density
Density :YMC
Density YMC ***