Manual

6
Specications
Engine Name T344
Engine Type 4-cycle, single cylinder, air cooled
Dry Weight (Without guard and strap) 5.9 kg/13.0 lb.
Bore x Stroke 38 x 30 mm (1.5 x 1.2 in.)
Displacement 34 cc (2.1 cu. in.)
Fuel/Oil Ratio 50:1 with *ISO-L-EGD or JASO FD class engine oil
Fuel Tank Capacity 700 ml (23.7 oz.)
Carburetor Type Diaphragm-type carburetor
Ignition One-piece electronic, program-controlled
Spark Plug** NGK CMR5H
Spark Plug Gap 0.6 mm (0.024 in)
Torque 16.7 - 18.6 N∙m (148-165 in • lbf)
Air Cleaner Type Foam pre-lter; sealed felt main lter
Starting Method Recoil
Stopping Method Slide switch
Transmission Type Automatic, centrifugal clutch w/bevel gear
Engine Idle Speed 2,900 RPM
Clutch Engagement Speed 4,500 RPM
Wide Open Throttle Speed (W.O.T.) 10,350 RPM
Specications are subject to change without notice.
Assembly
Prior to Assembly
Before assembling, make sure you have all the components required for a complete unit and inspect unit and components
for any damage.
IMPORTANT!
The terms “left”, “left-hand”, and “LH”; “right”, “right-hand”, and “RH”; “front” and “rear” refer to directions as viewed by the
operator during normal operation.
■ Engine and shaft assembly
■ Cutting attachment shield
■ Cutting attachment
■ Owner’s/operator’s manual
■ Emission Control Warranty Statement
■ Safety Glasses
■ Assembly Tool (s)
An Emission Control Label is located on the engine. (This is an EXAMPLE ONLY; information on label varies by engine
FAMILY).
PRODUCT EMISSION DURABILITY (EMISSION COMPLIANCE PERIOD)
The 50 or 300 hour emission compliance period is the time span selected by the manufacturer certifying the engine
emissions output meets applicable emissions regulations, provided that approved maintenance procedures are followed
as listed in the Maintenance Section of this manual.
Emission Control (Exhaust & Evaporative)
EPA 2010 and Later and/or C.A.R.B. TIER III
The emission control system for the engine is EM (engine modication) and, if the second to last character of the Engine
Family on the Emission Control Information label (sample below) is “C”, “K”, or “T”, the emission control system is EM and
TWC (3-way catalyst). The fuel tank/fuel line emission control system is EVAP (evaporative emissions). Evaporative emis-
sions for California models are only applicable to fuel tanks.