Owner Manual

9
WATER DRAINAGE
When the water tank is full, the unit will stop automatically. When this
happens,the TANK FULL light will show on the control panel.
NOTE: Only empty the water tank when it is full or before moving or storing
the unit.
There are two ways to dispense collected water.
USE THE TANK
When the tank is full, the unit will automatically stop running, and the Tank
Full indicator will illuminate.
Slowly pull out the tank. Grip the tank by its handle securely, and carefully pull it out. Empty the water tank
and reinsert it into the dehumidifier. The tank must be in place and securely seated for the dehumidifier to
operate again. The dehumidifier will re-start when the tank is restored in its correct position.
NOTES:
When you remove the water tank, do not touch sensors or any parts which are situated behind tank.
Otherwise it may damage the product. Be sure to push the tank gently all the way into the unit. Banging
the bucket against anything or failing to push it securely into place may cause the unit not to operate. Do
not remove any parts from the water tank or tank enclosure,otherwise the water full sensor will no longer
be able to detect the water level correctly and water may leak from the water tank.
CONTINUOUS DRAINAGE
Water can be automatically plumbed in or drained into a sink, a larger recipient or through the wall into
an outside drain by attaching a pipe to the unit [0.354 in (9mm) internal diameter]. One 23.62 in (60cm)
pipe is supplied. Insert the pipe into the drain outlet at the back of the unit as shown here.
Make sure the connection between pipe and the drain outlet is tight and does not leak. Then direct
the pipe to a suitable drainage point. This unit uses gravity to dispose of water,hence the drain
should be lower than the water outlet on the unit. Be sure to run the water pipe downward and let the
water to flow out smoothly. Do not kink or bend the pipe.
Notice:Pls make sure that the water tank is properly installed on the machine when you use continuous
drainage.