User's Manual

Table Of Contents

▶ Initializing the Mobile Device back to the factory default

settings (Hard Reset)

There are many possible reasons why the Mobile Device has to be

reinitialize back to the factory default setting, like, when the device

would not respond even after performing a reset or the user forgets the

password set on the system. This process is called “Hard Reset.” When

performing hard reset, all information in the RAM (files, system settings,

installed programs) will be cleared.

To insure the safety/integrity of the information, make a backup or

make a copy of it in the SD card before performing a hard reset.

Restore the information after the hard reset process to recover the

information.

As said earlier, all information stored in the Mobile Device’s RAM will

be cleared after performing a hard reset. However, it is possible to

recover information backed up to the PC, SD card or the Web folder

To perform a Hard Reset:

1. Remove the Mobile Device form the cradle.

2. Perform the following depending on the power state of the device:

• When the device is powered on, while holding down the [Left-

Down]-[Right-S] buttons, poke the reset key using the Stylus

pen.

• When the device is powered off, while holding down the [Left-

Down]-[Right-S] buttons, press the [power on] button.

3. Wait until the Mobile Device re-starts.

Initialize to factory default

VI-2