User's Guide

4
Gcube Series Receipt Printer
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Caution
Some semiconductor devices are easily damaged by static electricity. You should turn
the printer “OFF”, before you connect or remove the cables on the rear side, in order
to guard the printer against the static electricity. If the printer is damaged by the static
electricity, you should turn the printer “OFF” and contact your dealer for assistance.
INTRODUCTION
The Gcube Series Roll Printer is designed for use with electronic instruments such
as system ECR, POS, banking equipment, computer peripheral equipment, etc.
The main features of the printer are as follows:
1. High speed printing
GCUBE-100 : 250mm/s, 59 lines per second(12X24 Font)
GCUBE-102 : 250mm/s, 66 lines per second(12X24 Font)
2. Low noise thermal printing.
3. Support a variety of interfaces :
USB+WLAN+EHTERNET
4. Jam free (Implementation of automatic return of Cutter Jam)
5. Characters can be scaled up to 64 times compared to it’s original size.
6. The data buffer allows the unit to receive print data even during printing.
7. Bar code printing is possible by using a bar code command.
8. Peripheral units drive circuit enables control of external devices such as
cash drawer.
9. 2-dimensional bar code(QR code, PDF-417) and Two color printing.
Please be sure to read the instruction in this manual carefully before using Gcube
Series.
NOTES : The Power outlet shall be near the equipment and it should be easily accessible.
NOTES : Ethernet communication is disabled in USB, wireless communication.