User's Manual

Shin Chuan Computer
User’s Manual
SC800/SC820
2-27
6. Good scanning position.
The reading range is from 40 to 300mm distance.
1) Decrease the scanning distance to the bar code when scanning small
barcodes.
2) Increase the scanning distance from the bar code when scanning large
barcodes
3) The scanning area is visible by a red laser beam.
7. Bad scanning position.
1) Make sure that the laser beam sweeps across whole bar code.
2) Scanning operations may fail if the laser beam is positioned as below.
8. upon reading a barcode, the red LED indicator turns on until the trigger is
release or after five seconds. The green LED and the beep tone indicates
a good read.
Note: This product scans using laser light. Never look directly into the laser
light or shine the laser light into the eyes.
2.5.8 Reading barcodes, 2D CMOS version.
The 2D CMOS version can read both 1D and 2D bar codes. To use the scanning
function, complete the following steps:
1. If you have not already done so, remove the protective plastic film before using
devices equipped with a 2D CMOS bar code reader.
2.
Select Start > Setting > Control Panel > Barcode Scanner Settings
3. Run the WordPad software program.
4. Press one of the three bar code reader trigger buttons.
5. Aim the scanning beam at the center of bar code. To assists in aiming, there are
4 green aiming light spots. The bar code should be between the outside 2 green
spots. The scanner is in focus in case the center 2 green spots joins into 1 spot.