User's Manual

Shin Chuan Computer
User’s Manual
SC800/SC820
2-11
2.4.3 Calibration of the touch Screen
On the initial boot-up of the PDT, the stylus
calibration screen (Labeled Align Screen)
opens. Use the stylus to press and hold
briefly on the center of each target as it
moves around the screen.
If necessary, adjust the backlight on the
PDT to make the screen readable.
(See below 2.4.4. Adjust the brightness).
When you feel the touch screen function
is poor or the operation does not match
the exact location it should be, please
recalibrate the screen by using the stylus
to tap the Start > Settings > Figure 2-13 Calibration
Control Panel > Stylus, to open the
“Calibration” to recalibrate again.
2.4.4 To mute the Sound for SC800
To mute the sound, press the key first, and then press the key to
turn off and turn on the sound.
2.4.5 Adjusting the Sound for SC820
The factory default for the sound is in Middle level. You can adjust the sound to
meet your environment and comfort as:
1) Increase high voice: Press the key and then press the key to
increase high voice.
2) Decrease low voice: Press the
key and then press the key to
decrease low voice.