User's Manual
Shin Chuan Computer
User’s Manual
SC800/SC820
2-10
2.4. Handling the PDT
2.4.1 Starting the PDT
Press the Power key to turn on/off the PDT. If the PDT does not power on,
perform a cold boot. See 2-7 Resetting the PDT.
CAUTION: When a battery is fully inserted in PDT for the first time, upon
the PDT’s first power up, the device boots and powers on automatically.
Figure 2-12 Starting the PDT
2.4.2 Power on / off
¾ To turn on the PDT
Press the Power key briefly (
). If the PDT does not power on, perform the
cold reset. See chapter 2.7.1.
As the PDT initializes its file system, it splash screen displays for about 30
seconds followed by calibration screen. Every time you perform a cold reset,
these screens will also appear.
To turn off the PDT, just press the Power key again. This action does not actually
turn off the PDT, it only turns the PDT into suspend mode. All running applications
remain as you left them, until you press the Power key again to resume operation
of the PDT
When the PDT is powered on for the first
time, it initializes its system. A splash
screen (figure 2-12) appears for a short
period of time followed by the WinCE 5.0
window.
This section offers the basic procedures of
PDT using.