User Manual

3-24
3.2.3 Bluetooth Device Properties
Table 3-20 Bluetooth Device Properties
ICON ITEM & FUNCTION
z “BT Service” Tab ( Figure 3-25) :
9 Tap the “Enable Bluetooth Device” to enable Bluetooth device.
9 Wait for 20 seconds in order to initialize the Bluetooth hardware
correctly.
9 Click “Scan Device Service” to pop “Bluetooth Manager”
window. Then tap the Scan Device button to initiate a scan for
Bluetooth hardware. The Bluetooth manager lists the Bluetooth
devices that it finds, see Figure 3-26. If Bluetooth hardware is
not found the Bluetooth Hardware Error window appears, see
Figure 3-27. Table 3-21 described the Bluetooth Icons.
9 Double tap the device to connect to on the device list. The
Bluetooth Manager Authentication window appears. Tap No to
connect to the device without authentication, or tap Yes to
authenticate the device before connecting. (Figure 3-28)
9 If the Yes button was selected in the Bluetooth Manager
Authentication window, the enter PIN windows appears. Enter a
PIN (between 1 and 16 characters) in the Enter PIN: text box,
and tap OK. The mobile computer sends the PIN request to the
device for bonding. (Figure 3-29)
9 When prompted, the same PIN must be entered on the other
device. When the PIN is entered correctly on the other device,
the bonded icon appears on the device list. (Figure 3-30)
z “Serial Port” Tab ( Figure 3-30-1) :
9 Tap the “Enable Bluetooth Device” to enable Bluetooth device.
9 Wait for 20 seconds in order to initialize the Bluetooth hardware
correctly.
9 If want to use Virtual com, only SPP base profiles are
supported.(i.e. Printer, Modem, and LAP).Switch to “Serial
Port” tab, and will see the devices you had trusted or active.
Select the device that you want to map a virtual com and which
virtual com you want to use.
9 Now COM1 has mapped for BT device.