User's Manual

A-3
A.1.2 Decoder Setup
Function Explaining:
Item Function Explaining
No Read
Timeout
Maximum time (in milliseconds) that the imager will attempt
to decode before declaring a “No Decode” condition. If
attempting to decode using the trigger key, the imager quits
decode attempts even if the trigger key remains depressed.
You will not be able to start a new decode using the trigger
until after the trigger is released. The timeout also applies to
the decode operation of the imaging technology. The Timeout
range is 0 meaning no timeout (i.e., infinite) to 300,000.
Multiple
Symbols Mode
Enables/Disables multiple symbols decoding. Normally the
imager stops attempting to decode when a bar code symbol is
decoded. In multiple symbols mode, the imager will not stop
until the trigger is released or a “No Decode” timeout occurs.
The same bar code will not read again until current decoding
stops.
Aimers During
Capture
Enables/Disables aimers during decoding.
Center Window
Decode Enable
A decoded symbol is returned only if it intersects a rectangle
specified by the center window.
Center Window
Center Window indicates the percent-age of width and height
of the center decode rectangle, relative to the entire image. The