User's Manual

LED Indicator

There are two LED on the RFID EM module, a Green LED and a RED LED. The Green LED

will flash twice with duration of 0.5 sec upon power on and will stay off afterward. The Green

LED will flash once (0.1sec ON) if any command issued through the system connector is

executed successfully. The RED LED will flash once (0.1 sec ON) if command received

through the system connector is not being carried out successfully.

The changes or modifications not expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment.

To comply with the FCC RF exposure compliance requirements, this device and its

antenna must not be co-located or operating to conjunction with any other antenna or

transmitter.

Note: This equipment has been tested and found to comply with the limits for a Class B Digital

Device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instruction, may cause harmful interference to radio communication.

However, there is no grantee that interference will not occur in a particular installation. If this

equipment dose cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on , the user is encouraged to try to correct the

interference by one or more of the following measures:

--Reorient or relocate the receiving antenna.

--Increase the separation between the equipment and receiver.

--Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

--Consult the dealer or an experienced radio/TV technician for help.