Specifications
22
When installing a band type
* If using the band adapter (SM-AD67), a support bolt will be necessary. A protector and a mounting washer will not be
needed. Use the SM-AD67 in combination with the FD-6770. The SM-AD11/15 cannot be installed.
Support bolt
Band adapter
Tightening torque:
5 - 7 N·m {43 - 60 in. lbs.}
When installing the components to carbon frame/handle bar surfaces, verify with the manufacturer of the carbon frame/parts
for their recommendation on tightening torque in order to prevent over tightening that can cause damage to the carbon
material and/or under tightening that can cause lack of fixing strength for the components.
Clearance 1 - 3 mm
Chain guide outer plate
2.
Adjust so that there is a clearance of 1 - 3 mm between the chain guide
outer plate and the large chainring.
Tightening torque:
5 - 7 N·m {43 - 60 in. lbs.}
0.5 - 1.0 mm
Chain guide
Front chainwheel
(large chainring)
3.
Use a 5 mm Allen key to secure the chain guide outer plate so that the
flat part of the plate is directly above the large chainring and so that
the rear edge of the chain guide is within 0.5 – 1.0 mm from the front
edge of the chain guide.