Specifications

20
INSTALLATION
 Installation of the dual control lever
Open up the bracket cover from the front, and then use a 5 mm Allen key to tighten the mounting nut in order to secure the lever
unit.
Bracket cover
5mm Allen key
Tightening torque:
6 - 8 N·m {52 - 69 in. lbs.}
When installing the components to carbon frame/handle bar surfaces, verify with the manufacturer of the carbon frame/parts for
their recommendation on tightening torque in order to prevent over tightening that can cause damage to the carbon material and/
or under tightening that can cause lack of fixing strength for the components.
 Installation of the brake cables
Cables used
Inner cable ... 1.6 mm dia. SLR outer casing ... 5 mm dia.
Use cables which are long enough so that they still have some slack even when the handlebars are turned as far as they will
go to the left and to the right.
1. Gently pull the brake lever.
2. Pass the inner cable through from directly in front, set the inner cable drum
into the cable hook, and then install the outer casing from the opposite side.
Outer casing
Inner cable drum
Cable hook