Specifications

Be sure to also inform users of the following:

When the system fails to operate, the system may be recovered by resetting the system power.

After the battery is removed, about one minute is usually required for the system power to reset.

In the case of using SM-BTR1

Remove the battery from the battery mount. After about one minute, install the battery.

In the case of using SM-BTR2

Disconnect the plug from SM-BTR2. After about one minute, insert the plug.

When the product is reassembled or replaced, it is automatically recognized by the system to allow operation according to the

settings.

If the system does not operate after reassembly and replacement, follow the system power reset procedure above to check the

operation.

For Installation to the Bicycle, and Maintenance:

If the component configuration changes or malfunction is observed, use the E-tube Project software to update the firmware of each

component to the latest version and perform a check again.

Also make sure that the E-tube Project software is the latest version. If the software is not the latest version, the component

compatibility or the product functions may not be sufficiently available.