Instruction manual

17
4. Functions and Operation
4.7 Comparator Mode (checkweighing)
When COMP lamp is on and mass value from the balance is printed, checkweighing result
“LOW”, “OK” or “HIGH” will be attached to each mass value. Checkweighing is performed according to
the two preset thresholds as below.
HIGH (over)
HIGH threshold
OK (pass)
LOW threshold
LOW (under)
4.7.1 Setting comparator thresholds
[setting procedure]
Verify function lamp
is off. If not, press FUNC key to turn it off.
Verify COMP lamp is off. If not, press COMP key to turn it off.
Set HIGH threshold and LOW threshold in this order as the following.
Note
After HIGH threshold has been set, it is stand-by for the LOW threshold setting.
At this time, key operations except for , , and are invalid.
(example)
(1) Press Reset key
.
(2) Key in HIGH threshold. １ ０ ０ ・ ５
(3) Press COMP key . Print-out HIGH=___100.5
(4) Key in LOW threshold. ９ ９ ・ ５
(5) Press COMP key . Print-out LOW_=____99.5
Note
A comparator threshold must be a positive value of not more than 10 digits.