User's Manual

BATTERY INSTALLATION
BASIC OPERATION
2017 MerchSource, LLC. Irvine, CA 92618. The Black Series™ name and all associated logos are trademarks of MerchSource LLC. All rights reserved. The artwork and design of this package are protected by US copyright law and may not be reproduced, distributed, displayed, published or used for any purpose without prior written permission. It is not permitted to alter, remove or reproduce any trademarks or copyright notice from this package. PATENT PENDING
NOTE: For best operation, use on a hard surface.
0000000 (00000)
Made in China
SAFETY WARNINGS - PLEASE READ BEFORE USING PRODUCT
Not recommended for children under 6 years of age. As with all electrical products, precautions should be observed during handling and use to reduce the risk of electrical shock. It is recommended that this toy and all accessories be periodically examined for potential hazards and that any potentially hazardous parts be repaired or replaced.
Operation requires 6 “AA” 1.5V batteries (not included) for ATV and one 9V battery (not included) for radio controller. • Carefully remove items from package. • Locate the battery compartment on the underside of the ATV and wireless controller. • Turn the battery compartment lock on the bottom of the ATV to remove the battery compartment. • Insert 6 “AA” 1.5V batteries according to the polarity diagram located on the battery tray. (Fig.1) • Replace the battery compartment. • Slide open the battery compartment door of
the controller. (Fig.2)
• Insert the one 9V battery following the correct polarity. • Replace the battery compartment door.
BATTERY WARNING:
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
• Insert batteries using the correct polarity. Do not short-circuit the supply terminal.
• Remove batteries when not in use. Recycle or dispose of exhausted batteries according to
federal, state, and local laws. Do not dispose of batteries in a fire - they may leak or explode.
• Only use manufacture specified battery(ies), charger(s) and/or adapter, if applicable, specified
by the manufacturer.
• Always use, replace, and recharge (if applicable) batteries under adult supervision.
KEEP THIS PACKAGE FOR REFERENCE AS IT CONTAINS IMPORTANT INFORMATION.
FULL FUNCTION
REMOTE CONTROL
OFF/ON SWITCH
FORWARD & REVERSE LEFT & RIGHT
LEFT JOYSTICK
RIGHT JOYSTICK
OPERATING CONTROLS
• Switch both the vehicle and controller power switches to the “ON” position. • Adjust the steering alignment lever located on the bottom of the vehicle
(between front wheels) if the vehicle does not run straight when moving forward.
STEERING ALIGNMENT ADJUSTMENT: To fine-tune the steering control, locate the alignment dial on the underside of the chassis. Starting with the
dial in the middle position, test drive your car and adjust as needed. Should the car pull to the left or
right, simply move the dial until your car drives
straight without touching the directional controller.
L R
L R
LATCH
DOUBLE SIDED BATTERY TRAY
(REQUIRES 6 “AA” 1.5V BATTERIES)
Fig.1
ON/OFF SWITCH
STEERING ALIGNMENT LEVER
RADIO CONTROLLER USES ONE “9V” BATTERY (NOT INCLUDED)
ON/OFF SWITCH
IS LOCATED ON FRONT
OF CONTROLLER
Fig.2
WIRELESS
ACTION!
RC
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
FULL FUNCTION
REMOTE CONTROL
Colors and styles may vary. ATV requires 6 “AA” batteries (not included). RC controller requires
one 9V battery (not included). See bottom panel for complete operating instructions.
3
LED
LIGHTS
VERSATILE
OFF-ROAD RACING PLUS
EXTRA-BRIGHT LED LIGHTS
COMPETITIVE
AVAILABLE IN 2 FREQUENCIES
FOR TWO PERSON PLAY
CORDLESS
REMOTE CONTROL FOR FULLY
FUNCTIONAL RACING ACTION
3
LED
LIGHTS
features 3 extra
bright LED lights
knobby tires for
all-terrain racing
sport quad
radio controlled all-terrain vehicle
sport quad
radio controlled all-terrain vehicle
sport quad
radio controlled all-terrain vehicle
removable articulated
racing figure
AVAILABLE IN
2 FREQUENCIES!
KNOBBY TIRES FOR ALL-TERRAIN RACING
sport quad
radio controlled all-terrain vehicle
removable articulated racing figure
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
2017-05-11_BS_RCATV_BluRed_Blk
Black Series
4
Lisa Nagamoto
4 Color Process
Dinh Tran
Helvetica, Univers, VerdanaAdobe Illustrator CC (live)/CS4 (OL)
Matte PP Coating
12.66” L x 8.75” H x 7.875” W - 32.16cm L x 22.23cm H x 20cm W