A/V Receiver Operating Instructions

7
CENTER
SPEAKER
FRONT B SPEAKERS
• The COAXIAL or the OPTICAL DIGITAL OUTs of the components
that are connected to CD, TAPE MONITOR and VIDEO 1-VIDEO 5
of this unit can be connected to these DIGITAL INs.
Notes :
• After making digital connections, be sure to match the DIGITAL INs
to the corresponding input source respectively. (For details, refer to
"When selecting the DIGITAL IN SETUP" on page 41.)
• A digital input should be connected to the components such
as LD player, CD player or DVD player, etc. capable of
outputting DTS, Dolby Digital or PCM format digital
signals, etc.
• If the component with OPTICAL IN jack is connected to
the OPTICAL OUT jack of this unit, you can record the
high quality sound of CDs, etc. without degradation.
• For details, refer to the operating instructions of the
connected component.
• When making the COAXIAL DIGITAL connection, be
sure to use a 75 Ω COAXIAL cord, not a conventional
AUDIO cord.
• All of the commercially available optical fiber cords cannot
be used for the equipment. If you have a question about the
suitability of a particular cord, please consult your dealer or
nearest service organization.
■ CONNECTING DIGITAL INs and OUT
■ CONNECTING SYSTEM CONTROL
■ CONNECTING DC OUT
• Use these jacks when adding additional amplifiers.
• Connect the PRE OUT jacks to the powered speakers or the power
amplifiers connected to speakers respectively.
• Only when enjoying 6.1 or 7.1 channel surround playback, make the
surround back connections between the audio equipment.
• To emphasize the deep bass sounds, connect a powered subwoofer.
• To enjoy deeper bass sounds, connect an additional powered subwoofer to
the SUBWOOFER 2 jack.
Front speakers
Power amplifier
Surround speakers
Power amplifier
Surround back speakers
Power amplifier
Front center speaker
Powered subwoofer
■ PRE OUT connections
Power amplifier
System
control
cord
Sherwood component
with DIGI LINK II or III
CD player
Tape deck
Graphic equalizer
DVD player
• Connect this jack to the DIGI LINK jack of the
external Sherwood component that uses the DIGI
LINK II or III remote control system.
• Connect a component that needs to be triggered by DC
under certain conditions(screen, power strip, etc.) (For
details, refer to the operating instructions of the
component to be connected.)
Note
• This output voltage (15 V DC) is for (status) control only,
it is not sufficient for drive capability.
Additional powered subwoofer
Component(such as an MD recorder,
CD recorder) with OPTICAL DIGITAL IN
Component to be triggered by DC
Component with OPTICAL DIGITAL OUT
Component with COAXIAL DIGITAL OUT
Component with OPTICAL DIGITAL OUT
Component with OPTICAL DIGITAL OUT
Component with OPTICAL DIGITAL OUT
Component with COAXIAL DIGITAL OUT
ENGLISH