Installation manual

6
AUTO/MANUAL
ROCKER SWITCH
FAN
CONTROLLER
HEAT OUTPUT
KNOB
DIAL-A-FIRE
GREEN LIGHT
HOW TO START YOUR PELLET APPLIANCE
1. Fill hopper with pellets.
2. Switch the power on by pushing the
rocker switch to the manual position.
3. Turn Dial A Fire knob to the 12 o’clock
position. (The lower grade pellets may
need a higher setting on the feed rate.)
4. Approximately 15 minutes after the fire
was lit, the green light should come on.
WHEN THE GREEN LIGHT COMES
ON, PUSH THE ROCKER SWITCH TO
THE AUTO POSITION. Now the stove
will shut off automatically if the fire goes
out.
5. Wait until the fire is established, then turn
the Dial A Fire knob clockwise to the
desired heat output. (The stove may not
be able to burn in the BLUE ZONE if poor
quality wood pellets are being used.
Adjust the slider damper to the
appropriate setting.
6. Adjusting the blower speed control knob
will vary the rate of airflow into the room
by varying the speed of the convection
blower. *NOTE: The convection blower
may cycle to high automatically
depending on the setting of the Dial A
Fire knob and the blower speed control
knob.
TURNING YOUR PELLET APPLIANCE OFF
The auto/manual switch must be in the AUTO position during operation. To turn the stove off,
simply turn the HEAT OUTPUT knob (knob “B”) counter-clockwise until the knob clicks to the “off”
position. This will stop the feed of pellets. The blowers will continue to run and cool the stove.
SPECIAL NOTES
If the stove is left in the manual mode after the green light comes on, the auger will continue to feed
pellets. Pellets may over flow the burn-pot after the fire goes out and also re-light.
The scale on knob “B” represents a range, not exact times. Wood pellets of differing quality may effect
the performance/heat output of the stove. If the stove has trouble operating at the end of its range,
adjust the heat output knob back slightly.