Product Manual

ManualsBrandsSherrilltree ManualsArboricultureArborTie Heavy Duty Tree Anchoring Kit

ArborTie

AT HD 15 HEAVY DUTY ANCHORING KIT

AT HD15 KIT CONTENTS

INSTALLATION INSTRUCTIONS

SPECIFICATIONS + FEATURES

FEATURES

• 900 lb. break strength ArborTie

Green never

damages bark

• Reusable Steel Eye Anchors

• Economical

• Easy Installation

• Assembled in the USA

APPLICATIONS

Professional anchoring of trees

up to 6” in caliper

(3) 10’ lengths of ArborTie

Green.

Flat-woven polypropylene material,

lock stitch with rounded weave. 3/4”

(1.9cm) wide, and 900 lb. (409.2 kg)

break strength

DeepRoot Green Infrastructure, LLC

101 Montgomery Street, Suite 2850, San Francisco, CA 94104 USA

800 ILV ROOT (458.7668) 800.277.7668 www.deeproot.com

The ArborTie

Heavy Duty Anchoring Kit is the best way to secure trees in high wind areas, or for any trees that need

additional support. ArborTie

never damages the tree, and our tough steel eye anchors are easy to install.

ArborTie AT HD15

(3) 15" Steel Eye

Anchors

Eye opening is 1"

diameter

(1) individually

packaged ArborTie

Heavy Duty

Anchoring Kit

This end to

anchor

This end to

anchor

This end to

anchor

This end to

anchor

This end to

anchor

1. Tie a simple knot 18"- 24"

from either end of

the ArborTie

2. Wrap this end around

tree. Begin a new knot

below the knot that was

tied in Step 1.

6. Secure long end of ArborTie

the eye of the anchor. Add tension

to the ArborTie

by using a straight

rod to turn (screw) the anchor into

the ground outside the planting hole

at a 45 degree angle to the tree

trunk.

7. When screwing the anchor into the

ground, make sure the eye opening

is buried. Anchor eye should be just

even to soil level, as shown above.

8. Anchor should be placed outside

of planting hole and screwed

into the undisturbed soil until the

ArborTie

is taut.

9. Repeat steps 6-8 for each

remaining anchor. Anchors

should be evenly spaced

around the tree base.

3. Follow motion of ArborTie

as shown, ﬁ nishing the knot

by pulling tightly on points A

and B at the same time.

4. Slide the completed knot

just up to the knot tied in

Step 1. Fasten free end to

anchor.

5. The ArborKnot

expands

as the tree grows, providing

secure, girdle free attachment

of ArborTie

to tree.