Instructions

FIGURE 20—The Sherline 8730 CNC Rotary Table with stepper motor can be plugged

directly into the A-Axis cord pre-wired into your computer to operate as a 4

axis.

Definitions and Codes

The word definitions listed below were copied from the Linux CNC website. It’s where I

gathered the information to write part two of these instructions. It’s worth reading and

using to go to the next step in programming, but for the time being stick with just my

instructions. I never intended to write a complete programming manual and was only

interested in writing enough instructions to get you up and running in the marvelous

world that we call CNC.

http://linuxCNC.org/handbook/g-code/g-code.html