Instructions
x.5
g00 g40 g90 x0 y1 z0
m2
%
With comments
%
g00 g40 g90 x0 y1 z0
g41 d1 x0 y.5
g01 y0 f16
Last time, I started at y1 position so I could enter into the cutter comp mode in
two moves and coming in from the correct direction (remember—gear down-
touch down).
y-2.000
x-1.7032
g03 x-2.2013 y-2.4564 i0 j-.5 –Last time, The x and y positions where the arc
ends.
g01 x-2.2488 y-3.000
x-4.000
y0
x0
x.5 –Exiting g41 mode in correct direction.
g00 g40 g90 x0 y1 z0
m2
%
Work out a couple of similar problems on your own while I get ahead of my students
again. Boy, you guys are smarter than I thought you were.
The plot is about to thicken with your next problem that I called the pulley
program.
Figure 12
57