Instructions

The Sherline CNC rotary table controller was designed by
Bryan Mumford at Mumford Micro Systems in conjunction
with Sherline Products, Inc. Thanks to John Wettroth for
advice and suggestions.
Bryan Mumford, Mumford Micro Systems
3933 Antone Road, Santa Barbara, CA 93110
Phone: [phone]
Fax: [phone]
[e-mail]
http://www.bmumford.com
Sherline Replacement Parts Orders: [phone]
Technical Assistance, Mechanical: [phone]
Technical Assistance, Programming (Bryan Mumford):
[phone])
Using a Riser Plate on Sherline Mills
As noted in the drawing above, the bottom of the stepper
motor extends about .25" below the bottom of the table.
On page 20 we provide a drawing of a riser plate that will
lift the rotary indexer enough to clear the mill handwheel
on Sherline mills. Four mounting holes marked “A” are
used to mount it to the mill table T-slots. If used on a non-
Sherline machine, you may eliminate these holes. You
may make the plate yourself from the drawing. Sherline
offers the plate as an accessory should you wish to or
-
der one ready-made. The finished block can be purchased
from Sherline as P/N 8710.
-15-