Sherline Mill and Lathe Specifications

• Starting current: 17 amperes instantaneous starting current (<100
milliamperes). This is also stall current in True RMS
• Max current at time of changeover from lower speed to higher speed:
Depends on load
• Type of motor: 3.00 inch (outer diameter) sub-fractional horsepower
brush-type permanent magnet motor
• Temperature rise at ambient 50° C.: Less than or equal to 45° C.
• Motor frame size: 3 inches
• End use of motor: Drive unit for lathe or mill
MOTOR TORQUE CURVE
NOTE: Electronic circuitry built into the speed control supplies a constant 90 VDC
output to the motor regardless of the input current from 100VAC to 240VAC, 50 or 60
Hz, so Sherline machines can be plugged in and used in any country in the world without
a transformer as long as you have the correct wall plug converter..
USE WITH AN INVERTER: This motor and speed control can be used with an inverter
that produces a sine wave. It cannot be used with an inverter that produces a square wave.