Sherline Lathe User Guide and Specifications

SAFETY RULES FOR POWER TOOLS
1. KNOW YOUR POWER TOOL-Read the owner's manual carefully. Learn its
application and limitations as well as the specific potential hazards peculiar to this
tool.
2. GROUND ALL TOOLS-If tool is equipped a with three-prong plug, it should be
plugged into a three-hole receptacle. If an adapter is used to accommodate a two-
prong receptacle, the adapter wire must be attached to a KNOWN GROUND.
Never remove third the prong. (See Figure 1.)
3. KEEP GUARDS IN PLACE-and in working order.
4. REMOVE ADJUSTING KEYS AND WRENCHES-Form a habit of checking
to see that keys and adjusting wrenches are removed from tool before turning on
machine.
5. KEEP WORK AREA CLEAN-Cluttered areas and benches invite accidents.
6. AVOID DANGEROUS ENVIRONMENT-Do not use power tools in damp or
wet locations. Keep work area well illuminated.
7. KEEP CHILDREN AWAY-All visitors should be kept a safe distance from the
work area.
8. MAKE WORKSHOP KID PROOF-with padlocks, master switches or by
removing starter keys.
9. DO NOT FORCE TOOL-Do not force tool or attachment to do a job for which
it was not designed. Use the proper tool for the job.
10. WEAR PROPER APPAREL-Avoid loose clothing, neckties, gloves or jewelry
that could become caught in moving parts. Wear protective head gear to keep long
hair styles away from moving parts.
11. USE SAFETY GLASSES-Also use face or dust mask if cutting operation is
dusty.
12. SECURE WORK-Use clamps or a vise to hold work when practicable. It is safer
than using your hand and frees both hands to operate the tool.
13. DO NOT OVERREACH-Keep your proper footing and balance at all times.
14. MAINTAIN TOOLS IN TOP CONDITION-Keep tools sharp and clean for
best and safest performance. Follow instructions for lubrication and changing
accessories.
15. DISCONNECT TOOLS-Unplug tool before servicing and when changing
accessories such as blades, bits or cutters.
16. AVOID ACCIDENTAL STARTING-Make sure switch is "OFF" before
plugging in power cord.
17. USE RECOMMENDED ACCESSORIES-Consult the owner's manual. Use of
improper accessories may be hazardous.
18. TURN SPINDLE BY HAND BEFORE SWITCHING ON MOTOR-This
ensures that the workpiece or chuck jaws will not hit the lathe bed, saddle or
crosslide, and also ensures that they clear the cutting tool.
19. CHECK THAT ALL HOLDING, LOCKING AND DRIVING DEVICES
ARE TIGHTENED-At the same time, be careful not to overtighten these
adjustments. They should be just tight enough to do the job. Overtightening may
damage threads or warp parts, thereby reducing accuracy and effectiveness.