Sherline Lathe User Guide and Specifications

FIGURE 5
Set the column on the base aligned with the mounting holes and hold it in position while
you insert the first screw up from the bottom of the base. Hand turn the first screw part
way in and then start the second screw. This can be done with the machine upright by
letting the base hang over the edge of your table or bench just far enough to expose the
first hole. Using the hex key, snug up both screws lightly first, and then tighten evenly.
Assembly of the model 2000 and related model 8-
direction mill columns
For specific directions on assembly of the various 8-direction columns and upgrades
introduced in August, 1998, click here. The Model 2000 mill and the related upgrades
that convert standard mills into 8-direction mills offer the ability to drill holes or do
machining operations from an almost infinite number of angles on parts mounted square
to the table.
Check tightness of all bolts
Vibration in shipping can cause some bolts or screws to loosen up. Before using your
new machine, check the tightness of all fasteners. It is also a good idea to check tightness