Sherline Lathe User Guide and Specifications

FIGURE 2
Next, see that the gib is in the proper position on the saddle. (See Figure 2.) It is taped
into position for shipping. Remove the tape holding it in place. If the gib has come off,
position it on the gib lock as shown.
Set the dovetail of the crosslide over the gib and matching dovetail on the saddle. Slide it
onto the saddle about 1/4" (6-7mm) until it stops. (See Figure 3.)
FIGURE 3
Look underneath and align the slide screw with the threads on the brass slide screw insert
on the side of the saddle. (See Figure 4.) Turn the crosslide handwheel clockwise to