Instructions

REFP/NDESCRIPTION
13571Vise base
23572Rotating base–vise
33573Clamp ring–vise
43574Vise clamp (4 req.)
5305610-32 T-nut (4 req.)
6406910-32 x 3/4” SHCS (6 req.)
7121110-32 x 5/16” SHCS (4 req.)
PART LISTING, P/N 3570
P/N 3570, Page 2 of 2
Precautions against overtightening
As with all accessories that clamp to the table, be
careful not to overtighten the T-nuts. You can easily
exert enough pressure with a hex wrench to bend the
T-slots and distort the table. This is not just a problem
on miniature machine tools, as overtightening can
break out the T-slots of the steel table of a full size
machine as well. You will need to develop a “feel” for
how tight you need to go to accomplish the job without
damaging your equipment.
Joe Martin, President and owner
Sherline Products Inc.
1
3
2
5
7
4
6
6
EXPLODED VIEW
NOTE: This part is made
from cast tooling plate. It
is more stable and flat but
doesn’t take anodizing or
engraving as well as bar
stock aluminum.
FIGURE 1—The mill vise location is shown with
dotted lines.
To find the center of rotation, indicate
in this surface on both sides of the
rotating base.
WITNESS MARK
ANGLE SCALE