Specifications

Page 11
Periodic Maintenance
The Sherbourn CD-1 unit requires no periodic maintenance.
Cleaning the CD-1
• If necessary, the CD-1 should be cleaned gently with a soft rag.
• If something sticky gets on the front panel or case of the CD-1, it should be cleaned with a mild
cleaning solution applied to a soft rag, followed by wiping with a clean rag dampened with plain
water and drying with a soft dry rag or cloth.
Note: DO NOT spray water or cleaning solution directly onto the Sherbourn CD-1 or into the
vents or CD loading slot.
Changing the batteries in the remote control
Note: Sherbourn recommends using high quality AAA batteries in the CD-1 remote control.
Note: To change the remote control batteries you will need a at tipped Phillips #2
screwdriver. DO NOT attempt to use a different size bit or damage will occur!
Note: Perform the following operation on a stable surface; use a cloth or paper towel to
protect the surface and the face of the remote control.
• Remove the six (6) Phillips head screws on the back of the remote and gently remove the back
panel.
• Remove the old batteries and discard according to battery maker’s instructions.
• Insert new batteries, making sure they are oriented correctly. (Use the diagrams in the battery
slots for reference).
• Replace the back panel back on the remote and reinstall the six (6) screws, turning clockwise
gently until a snug t is achieved. Do not over tighten the screws as you may damage the screw
heads and/or screw holes in the back of the remote.
• Your remote is now ready to use.