User manual

Page 24
PT-7030: User Manual
9. Random Button
When playing music from a USB stick, this button causes songs to be played in random order
(“shufe mode”).
10. Playback Buttons
These buttons provide basic playback controls for audio played from a USB stick.
11. Mode Control Buttons
The 2-CH Button changes the audio mode to Stereo, Down-Mix, or Bypass.
The PLCM Button toggles the audio mode to Pro Logic Cinema or Music.
The SUR+ button allows you to view or change the current surround mode and congure the
automatic dynamic range control. Press the Sur+ button to view the information; while the
information is displayed, the Lt and Rt navigation buttons switch between surround modes and the
Dn navigation button switches between dynamic range options.
12. Sel Button
Allows you to congure options for each zone. Press the Sel button repeatedly until the desired
zone appears in the display. Once the desired zone is selected, you have 10 seconds to make
changes. (Press an Input Selector button to choose a different input, or use the Volume + and
Volume -- Buttons to change volume for the zone.)
13. Input Selector Button
Each button directly selects an Input.
Note: You must congure the specic video and/or audio source for each input.
14. [UNUSED]
15. Multi (Input Selector Button)
Selects the 7.1 channel (“Multi-Channel”) unbalanced audio input.
Note: The remote control for the PT-7030 can be congured to use an alternate set of IR
control commands (to avoid conicts with the codes used by some other device). The
default command set is Set 1, and the alternate command set for the main zone is Set 2. To
congure the remote control to use IR Command Set 2, press the In2 and Number 2 buttons
on the remote AT THE SAME TIME. Then point the remote control at the PT-7030 and hold the
Number 2 button for at least ve seconds (a message will display on the front panel “AUD ID:
-->2” to acknowledge the change). To reset the PT-7030 and remote to use Set 1, repeat the
procedure using IN2 and the Number 1 button.
Note: The remote control for the PT-7030 can be congured to directly control Zone 2, Zone
3, or Zone 4. (This feature could be used to enable you to put IR repeater receivers in your
other zones and congure a remote control to work specically in each zone, or simply to
temporarily control another zone more easily from your main remote.) To congure the
PT-7030 remote control to control a specic zone, press the In2 button and the Number
button that corresponds to the zone on the remote control at the same time.
Zone 2 = press In2 and “3”
Zone 3 = press In2 and “4”
Zone 4 = press In2 and “5”
Press In2 and 1 (or 2 if you are using Command Set 2) to return the remote to normal.