User manual
Page 12
PT-7030: User Manual
Note: The output resolution is specied in the Video Setup Menu. Analog video inputs at any
resolution will be converted to the selected resolution for output (except 3D or 1080p/24).
HDMI inputs are ALWAYS passed through to the output at the resolution in which they are
received.
Note: HDMI video signals are subject to HDCP copy protection. Video may not be displayed
properly (or you may get a blank screen) unless all connected HDMI components, including
the display or TV, are compatible with the HDCP copy protection standard. (Third party
adapters which convert HDMI output to high-denition component video may not work
properly, depending on the copy protection status of the source material. Consult the
manufacturer of your adapter for details.)
Note: The HDTV Component Video outputs on the PT-7030 are subject to HDCP copy
protection. Component Video Outputs may not display 720p, 1080i, or 1080p video when
the source signal is copy protected. All sources will, however, be available when the
output resolution is set to 480p/576p. (Pending changes to the copy protection standard
requirements may result in no output at all from the component outputs with certain copy-
protected HDMI source content.)
Note: Most TV monitors with DVI-D connections can be successfully connected to the HDMI
Outputs on the PT-7030. There may, however, be compatibility issues with some older DVI-D
equipped monitors. DVI-D monitors must support the HDCP copy protection protocol to work
properly with copy protected content.
Note: By default, only audio received from the source component is sent to the TV via the
HDMI Outputs. To send decoded audio from the PT-7030 to the TV, select TV Mode in the
Video menu.