Operating instructions

Fig. 6 Optional Rack Panel assembly

Note 1 - Remove two M4 flat head screws from front panel of amplifier and use them to fasten the amplifier

to the Rack Panel as shown above. The amplifier front panel is not removed.

Note 2 - Fasten the Alignment Bar (when two amplifiers are used) to the bottom cover of the amplifier using

the two screws already in place. This will hold the back of the amplifiers in alignment.

Note 3 - When only one amplifier is mounted to the Rack Panel, the second opening can be covered with a

Cover Plate that is not part of this kit.

Each Rack Mount Kit contains:

Item Qty Name To Mount

(1) 1 Rack Panel

(2) 1 Alignment Bar

(3) 4 10-32 x 1" truss head screws Rack Panel

(4) 4 #10 shoulder washers Rack Panel

(5) 2 existing amplifier screws Alignment Bar

Separately available from Sherbourn:

(6) 1 Cover Plate with mounting screws

(2)

ALIGNMENT

BAR

AMPLIFIER

(1) RACK PANEL

(6) COVER PLATE

(ORDER

SEPARATELY)

NOTE 1

NOTE 3

NOTE 2

(5) EXISTING

SCREWS

(4) #10

WASHERS

(3) 10-32 x 1

SCREWS