True Wireless Earbuds USE INSTRUCTION F02 1
1 OVERVIEW Earbud Charging Case 2 How to Wear 1. Insert the earbud so the eartip gently rests at the opening of your ear canal. 2. Slightly rotate the earbud back until the eartip creates a comfortable seal at your ear canal.
1 Wear the earbuds for an extended period of time. If the eartips don’t feel comfortable or secure, try another eartip size. 2 There are 3 sizes eartip, small, medium, large. You may need to try all three eartip sizes or use a different size eartip for each ear. Change the Eartips 1. Holding the earbud, gently stretch the soft top of eartip and pull it away from the earbud middle. 2. Choose a new eartip. 3.
2) Then go to Bluetooth settings and choose F02, take out earbuds after successful connect. Note： • If fail to connect, close the case and repeat the above operation。 • Make sure no other bluetooth connection with the mobile device before connecting earbuds within range (30 ft or 9 m). Reconnect a device With earbuds in case and lid open, turn on the bluetooth, then the earbuds try to connect with the most recently-connected device automatically.
If fail to reconnect, then go to bluetooth setting and choose F02. Notes: • Make sure no other device connected with the earbuds within range (30 ft or 9 m). Disconnect a Mobile Device • Place earbuds into the case, and close lid. Then earbuds disconnect the device. • You can also go to Bluetooth settings to turn off Bluetooth.
4 Reboot the Earbuds If the earbuds are unresponsive, or unusual on sound, you can reboot them. 1 Go to bluetooth settings, delete the earbuds from the Bluetooth list on your device. 2 With earbuds in case and lid open, press and hold the case’ button until middle light slowly blink10 times, then blink fastly and stop at last. Reboot successfully.
5. Touch Control Double-tap either earbud: Play/Pause music,and Answer/End a call Triple-tap either earbud: Activate Siri /voice control, and decline a call Tap and hold right earbud for 3 seconds: Next song Tap and hold left earbud for 3 seconds: Last song Notes: • Don’t touch the control surface area until open lid 3 seconds later. • If touch control functions unnormally, put earbud into charging case with lid close, then take out again in 3 seconds after lid open. 6.
POWER OFF • Place earbud in the charging case, Close the case, The earbud power off. The case lights glow according to the charging status. • The earbud will power off in 2 minutes after fail to connect with a device. 7. Mic Both earbuds power on at the same time , right earbud’s mic works. When only remove one earbud from the case to use, its’ mic works, eventhough remove another earbud later.
case. 8. How to Charge Charge the Earbuds Place the earbud in the charging case and close the lid, then the case starts to charge the earbud. The case light glows for several seconds. Note: If the case has a low battery level, its’light blinks quickly to show warning when you press the key. At that time the case cannot charge earbuds.
Charging Time COMPONENT Charging time full Earbuds 1.5 hours Case 2.5 hours Charging Case Status Light When press the case key, the case lights show the charging case battery level. Light Activity Power Status No power 1-5%, Blink quickly, Warning to stop using, case cann’t charge earbud 5.
FCC WARNING: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
