Safety Information

4x 1.5V (AAA)

%,1'

This remote uses AAA battery or Ni MH battery, when the voltage is lower than 4.5V ± 0.2V, the LED starts flashing.

A. Find the coin button of the battery compartment from the bottom

of the remote and turn it 90 ° clockwise. Then the battery

compartment can be taken out; Install four AAA batteries according

to the polarity mark on the battery.

B. Reinstall the battery compartment,

insert the battery compartment into

the handle, and rotate the coin

button 90° counter clockwise . The

battery compartment is installed（

Note: type-C port is aligned with

bottom hole)

Rotate 90° clockwise

Rotate 90° counterclockwise

1.Switch on the transmitter.

4 Binding

2.Turn on the power switch on the

car, and the front light on the

car flashes.

3.Insert the binding plug into the BIND

channel slot on the car, if the LED stops

flashing, and stays lit permanently,

the binding procedure is completed.

Note: the wireless rc car has been connected to the remote. The above procedure is only necessary when use a

new remote or car.

Turn off the car: please turn off the power switch of the car first, and then turn off the power switch of the remote

to prevent the car from losing control.

Tip: if fail binding , please turn off the power switch of the car and remote , and restart the binding.

WARNING: DO NOT ATTEMPT TO CHARGE A NON

RECHARGEABLE BATTERY, OR IT WILL EXPLODE.

WARMING :DO NOT KEEP THE BATTERY IN THE

BATTERY COMPARTMENT FOR A LONG TIME TO

AVOID BATTERY OXIDATION AND DAMAGE THE

PRODUCT.

3 Transmitter battery installation