User's Manual

① In the process of pairing, please make sure the Bluetooth function of your smartphone
is enabled.
②If the watch cannot be found in the process of adding the device, or the watch cannot
be connected during use. Please turn on the watch, tap the “Settings” - “System settings”
- click“Factory settings”, then try to connect the watch again.
③ If the watch still cannot be found, exit and re-enter the“InxFit”APP to try again.
The connection status of the watch is shown ④ in the figure below:
Unconnected Connected
04 Operation
1. Open the control panel: Swipe down from top to bottom on the homepage of the watch
dial.
2. Message Notification: Swipe up from bottom to top on the homepage of the watch dial.
3. Main Interface: Click the power button.
4. Open the status display interface: Swipe to the left on the homepage of the watch dial.
5. Shortcut to switch the dial: Press and hold the dial interface for 2-3 seconds until the
watch vibrates once, and then swipe to left or right to select the dial.
6. Power-on: Press and hold the power button for 3 seconds (Power-off: Press and hold
the power button for 3 seconds when the display is on, then select power off)
7. Tap the power button to return to thehomepage on the watch dial