Service manual

Chapter 1 About the Product
processes them and displays them on the screen. You can set the alarm limit as required.
When the monitored parameter exceeds the preset alarm limit, the patient monitor will start the
alarm function. In addition, you can control the patient monitor through the control panel.
Usually, patient monitors are seen in some clinical areas in hospital, such as ICU, CCU,
intensive care units for heart disease patients, operating rooms, emergency departments and
observation wards. They can also be used in clinics. The PM-9000 Express patient monitor
should be run under the control of clinical staff.
PM-9000 Express patient monitor has the following functions:
Heart Rate (HR)
2-channel ECG waveform
ECG
Arrhythmia analysis and S-T analysis (optional)
Respiration Rate (RR) RESP
Respiration waveform
Pulse Oxygen Saturation(SpO
2
), Pulse Rate (PR) SpO
2
SpO
2
Plethysmogram
NIBP Systolic pressure (NS), diastolic pressure (ND), mean pressure
(NM)
TEMP T1, T2, TD
IBP CH1: SYS, DIA
CH2: SYS, DIA
IBP waveform
CO Temperature of blood (TB)
Cardiac Output (CO)
CO
2
End-tidal carbon dioxide (EtCO
2
)
Inspired minimum CO
2
(InsCO
2
)
Airway Respiration Rate (AwRR)
AG
Inhaled and exhaled CO
2
(FiCO
2
, EtCO
2
)
Inhaled and exhaled N
2
O (FiN
2
O, EtN
2
O)
Inhaled and exhaled O
2
(FiO
2
, EtO
2
)
Inhaled and exhaled anesthetic agent (FiAA, EtAA, where AA
refers to any of the following anesthetic agents.)
HAL (Halothane)
2