User's Manual

4).Fourth step:
Pairing successfully→headset with “bi,bi...”sound→red & blue lights flash slowly,single
& stereo are connected successfully.
*Only red light flashes slowly→single connected successfully.
*Only blue light flashes slowly→stereo connected successfully.
Note:
If headset cannot find the pairing equipment in 3 minutes will automatically shutdown.
If headset isn’t in pairing status,your mobile and other bluetooth equipments cannot search
headset,please set the headset on pairing status then your mobile can begin to search.
4．Start-up & Shutdown
a. Start-up headset
1)Shutdown status: Press S1 key for 2 seconds→red & blue lights flash at the same time for 1
time→then headset with “de...”sound→red light flash→
stop press S1 key→switch on headset
successfully, the headset enter into connecting mode.
2)automatic search has been paired device
connected to stereo while the blue light flash once per second,connected to a mono
while the red light flash once per second, connected on the stereo and mono at the
same time,red &blue light flash per second at the same time once, if not connected,
then enter the standby mode, the red light flashes continuously.
2. Shutdown headset
1）Switch on status:Press S1 key 3 seconds→red & blue lights flash at the same time for 1
time→headset with"de" sound→shutdown.
2）When Searching the equipment or without the receive range of headset,the headset will
automatically shutdown after not get any connection in 1 minute.
3. Low voltage checking
The power supply voltage below 3.0 V,red light flash quickly,headset with”bi-bi”sound,will
power off after 30 seconds.
E．Basic use method
Dial、Talk & Finish calls
Afer the bluetooth headset finish pairing with your mobile,you can use the headset to answer
the phone or enjoy the mobile setero music.
1. Mobile dial,talk and finish calls
Dial a call
Dial-up using the phone's keypad
1).using your phone, dial numbers as usual in the same manner, during connecting ,
headphones with vibration ring tones, When getting through,sound will be automatic in the
bluetooth headset,and the red light flash around 2 times/second.
2.Continuous press the S1 key twice, can automantic to dial the last phone you
called,during connecting , headphones with vibration ring tones,
after getting through