User's Manual

Button Operating Instructions
（Green Light）
ERROR(Red Light ）
CHARGE(Red
Light/Green Light)
Printer Status
OFF
OFF
OFF
Printer Close
Flash
OFF
OFF
Printer dormant
ON（Always）
OFF
OFF
Printer open and have paper
ON（Always）
Flash
OFF
Printer Open , without paper
CHARGE(Red Light)
Charged with Battery
CHARGE(Green Light)
Full of Battery
Display 1 or 2 shelf
Low power of Battery
Hold down power for 3 seconds
Printer OPEN/OFF
Under power on, the paper feeding begins when press 【FEED】 button
the printer paper feed
Power off the printer, then hold down the【FEED】button and press the
power button at the same time. Wait 2 seconds ,then loosen the【FEED】
button,the current setting will be printed out.
The printer Self test
Power off the printer, then hold down the【FEED】button and press the
power button at the same time. Wait until the power indicator &【ERROR】
led are both on, and then 【ERROR】led goes off, then loosen the【FEED】
button, the language setting status will be printed out.
Transformation in both English
and Chinese
Power off the printer, then hold down the【FEED】button and press the
power button at the same time. Wait until the power indicator &【ERROR】
led are both on, and then 【ERROR】led goes out, after, 【ERROR】led goes
on again ,then loosen the【FEED】button, the density setting status will be
printed out. (It has three levels setting for printing density, it is a circle
Low levelMiddle levelHigh levelLow level…, Please switch the density
status by repeating operation presented above.)
Set printing density
Power off the printer, hold down the【MODE】button and press the power
Hexadecimal printing