User Manual

Pow er off t he prin ter, t hen hol d dow n the【FEE D】
but ton and pres s the p ow e r butt o n at t h e same time .
Wai t 2 sec ond s , th en loos e n the【FE E D】bu tto n,
the cur r en t s ett in g wil l be pr in t ed out.
The printer Self test
Power off the printer, then hold down the【FEED】
button and press the power button at the same time.
Wait until the power indicator & 【ERROR 】led are
both on, and then 【ERROR】led goes off, then
loosen the【FEED】button, the language setting
status will be printed out.
Transformation in both
English and Chinese
Instruction Mannual
80MM Portable MINI Thermal Printer
5 6
5.The installation of the paper roll
The printer use 80MM thermal paper, and adopt to easy paper loading. So
the paper is very convenient install.
Paper diameter Max 40mm.
Thermal paper installation method is as follows:
（1
） Open the printer top cover
（2
） Thermal Paper as follow Graph to put into paper storehouse
（3）Put out a little of the paper outside printer,then close the top cover.
（4）Use paper sawtooth tear off redundant paper
Button Operating Instructions
ERROR(Red Light
）
OFF
OFF
OFF
Flash
CHARGE(Red Light
/ Blue Light)
OFF
OFF
OFF
OFF
Printer Status
Printer Close
Printer dormant
Printer open and have paper
Printer Open , without paper
（Blue Light）
OFF
Flash
ON（Always）
ON（Always）
CHARGE(Red Light) Charged with Battery
CHARGE( Light)Blue
Full of Battery
Display 1 or 2 shelf
Low power of Battery
Hold down power for 3 seconds Printer OPEN/OFF
the pri nte r pape r fee d
U n d e r p o w er o n , t h e p a p er f e e d i ng b e g i n s w h e n p r es s
【F E E D】 b u t t o n
Power off the printer, then hold down the【FEED】
button and press the power button at the same time.
Wait until the power indicator &【ERROR】led are
both on, and then 【ERROR】led goes out, after,
【ERROR】led goes on again ,then loosen the
【FEED】button, the density setting status will be
printed out. (It has three levels setting for printing
density, it is a circle Low levelMiddle levelHigh
levelLow level…, Please switch the density
Set pr inting density
status by repeating operation presented above.)
Power off the printer, hold down the【MODE】button
and press the power button at the same time. Wait
until the power indicator &【ERROR】led are both on,
and then 【ERROR】led goes out, then loosen the
【MODE】button. The printer turns into the hexadecimal
printing mode and print the presentation.Way to quit
hexadecimal printing : The way to quit hexadecimal
printing mode is switch off the printer .
Hexadecimal printing